Operation With A Load-Shedder; Led Switch Off Mode - DELTA DORE Tybox 5701 FP Installation And User Manual

5. Operation with a load-shedder

If a load-shedder is connected to the receiver, the heating will switch to Off during load-shedding requests.
When load-shedding is in progress, the green LED on the receiver flashes.

6. LED switch off mode

When the function for switching off the LEDs is active:
- When powering up (or restoring power), the LEDs are active.
- If the button has not been pressed after one minute, the LEDs switch off.
- A press of the button will authorise the illumination of the LEDS for one minute.
The backup and default pilot wire modes will still be signalled.
To enable/disable the function:
Press for 6 seconds, until the LED switches on without flashing.
> 6s
❶ Press the receiver button for 6
seconds until the red LED is on and
steady.
Release the button.
>3s
... ... ...
... ...
❷ The LED is flashing:
1 flash: function disabled
2 flashes: function active.
A short press enables you to switch
from one to the other.
OFF
> 1'
❸ A 3-second press validates the
selection and exits the mode.
The LEDs switch off after 1 minute of
inaction.
9