USE
1. Description
D
E
F
A
B
mode
C
2. Consultation or modification of temperatures
IMPORTANT: The radiator must be in automatic mode (AUTO, PROG ...), with its Comfort temperature set to the
maximum.
1
On the receiver:
Green LED illuminated = power supply OK
Red LED illuminated = heating request pending
3. Open window detection
If you have linked a motion detector to your setup.
When a window is opened, after 10 seconds the screen indicates:
Frost protection setpoint (7°C by default) alternating with OPEn.
4. Operation with the Tydom application
Features
Programming
Setting the temperatures
Pre-heat function
Absence Mode / Heat Mode
Deactivating the system
In "absence" mode, the screen of the Tybox indicates:
Frost protection setpoint (7°C by default) alternating with Ab.
In "system shutdown mode", the Tybox screen indicates OFF.
Temperature display
A
Select the mode
B
Adjustment buttons
C
Request in progress
D
2
mode
mode
(temperatures programmed in the app: special events, overrides,
Your equipment automatically determines the start-up time in order
to reach the temperature at the programmed time.
❶ Press any button to activate the screen. The current
mode is displayed:
ON = Thermostat on, OFF = Off.
To switch from one mode to another, press mode.
❷ From ON mode, wait a few seconds to display the set-
point temperature and change it using + or -.
Validation after 2 seconds if no buttons are pressed.
Via the Tydom App
Yes
Yes
scenario)
Yes
Yes
Yes
Heat mode
E
Battery level indicator
F
8