Standalone Operation - TASKING iSystem Infineon TC397XE Hardware User Manual

P7: AGBT
P7 connector exposes AGBT interface.
Signal Dir-
Signal Description
ection
I AGBT TX0_P
I AGBT TX0_N
Ground
Not Connected
Not Connected
Ground
Not Connected
Not Connected
Ground
Not Connected
Not Connected
Signal Direction is described from the BlueBox perspective.
Blue color marks the trace signals.
* Pin 18: TGO (AGBT Trigger out) is connected to the pin TP32.6. Before Revision C1 pin 18 was
NC (Not Connected).
BlueBox solution supporting AGBT (Aurora GigaBit Trace) interface connects to the P7 con-
nector.

Standalone operation

Infineon TC397XE Emulation Adapter is delivered with all components required for a Stan-
dalone operation.
Power supply
Use the enclosed IEA-PS Emulation Adapter Power converter and adapter.
A Power supply package, which is delivered with the Emulation Adapter, is required when:
·
The Emulation Adapter is used as a standalone device .
·
The target board doesn't provide an accurate supply voltage.
·
The target board doesn't provide sufficient current for the Emulation Adapter operation.
The Power converter can supply either 3.3 V or 5 V. The array of jumpers J0–J9 selects 3.3 V or
5 V voltage on the P3 connector, which connects to the Emulation Adapter.
Signal Pin Pin
TX0_P 1 2
TX0_N 3 4
GND 5 6
NC 7 8
NC 9 10
GND 11 12
NC 13 14
NC 15 16
GND 17 18
NC 19 20
NC 21 22
22-pin AGBT pinout (Revision C1)
Signal Signal Description
Vref Reference Voltage
DAP0 DAP clock
DAP1 DAP Data pin
NC Not Connected
DAP2 Optional 2nd Data pin
nTRST/DAPEN JTAG/Output
CLK+ AGBT Clock
CLK- AGBT Clock
TGO* AGBT Trigger out
AGBT ERR AGBT Error
RESET
Signal Dir-
ection
I
O
I/O
I/O
O
O
O
I
Reset I/O