Related Manuals for TASKING iSYSTEM AURIX DAP
Summary of Contents for TASKING iSYSTEM AURIX DAP
- Page 1 AURIX DAP Galvanic Isolation Adapter User Manual V1.4, June 2023 isystem.com/start...
- Page 2 General safety instructions Please read the following safety precautions carefully before putting this device to use to avoid any personal injuries, damage to the instrument, or to the target system. Use this instrument only for its intended purpose as specified by this manual to prevent potential hazards. Use included power cord and power supply The enclosed power supply has been approved for use by iSYSTEM.
-
Page 3: Table Of Contents
Contents Introduction ............................4 Package content ..........................5 Specifications ............................6 Device overview ..........................7 Connecting procedure ........................8 Accessories ............................9... -
Page 4: Introduction
Introduction Galvanic isolation is used where two electric circuits must communicate, but their grounds may be at different potentials. It is an effective method of breaking ground loops between the two circuits. Galvanic isolation is also used for safety, preventing accidental current from reaching ground through a person's body. -
Page 5: Package Content
Package content AURIX DAP 10-pin 1.27 mm Galvanic Isolation Adapter is delivered with the following components: AURIX DAP 10-pin 1.27 mm USB-C Power supply Ribbon cable Galvanic Isolation Adapter Ordering code: Ordering code: Ordering code: IEA-GI-AURIX IT5V2AUSBC-PS IA10PIN10PIN127-10... -
Page 6: Specifications
Specifications GENERAL Operating temperature 10°C to 40°C Storage temperature -10°C to 60°C MECHANICAL Size 65 x 40 x 19 mm Weight approx. 55 g ELECTRICAL Isolation Type Basic Isolation Ratings 1 kVrms VIORM * 560 V peak DEBUG TOOL SIDE Supply Voltage 5 V (via attached power supply) Max Supply Current... -
Page 7: Device Overview
Device overview A – DEBUG TOOL connector. B – TARGET connector. C – LED lights indicate power supply status. If LEDs on the GI Adapter are OFF, immediately turn everything OFF! D – USB-C Power supply socket (PWR). Use only original iSYSTEM USB-C Power supply for powering and connecting with the GI Adapter, otherwise the primary functionality of the GI Adapter would be counteracted. -
Page 8: Connecting Procedure
Connecting procedure Do not use a Grounding wire between the BlueBox and the embedded target since it would counteract the primary functionality of the Galvanic Isolation (GI) Adapter! 1. Make sure your hardware is powered OFF. Embedded Target · BlueBox ·... -
Page 9: Accessories
Accessories Ordering Code Description IC57000 iC5700 BlueBox IC57163-1 Infineon DAP/DAPE II Active Probe IC57164 Infineon AGBT Active Probe IC50163-2 10-pin 1.27 mm Infineon DAP2 Wide Debug Adapter IASAM22TRICOREPIN10-1 10-pin 1.27 mm DAP Adapter More information about our products on www.isystem.com or via sales@isystem.com. - Page 10 Visit our website for: Support - isystem.com/support · Tutorials - isystem.com/getting-started · Knowledge Base - kb.isystem.com · www.isystem.com...
Need help?
Do you have a question about the iSYSTEM AURIX DAP and is the answer not in the manual?
Questions and answers