Related Manuals for TASKING iSYSTEM Infineon TC397XE
Summary of Contents for TASKING iSYSTEM Infineon TC397XE
- Page 1 Infineon TC397XE Compact Emulation Adapter User Manual V1.4, June 2023 isystem.com/start...
- Page 2 General safety instructions Please read the following safety precautions carefully before putting this device to use to avoid any personal injuries, damage to the instrument, or to the target system. Use this instrument only for its intended purpose as specified by this manual to prevent potential hazards. Use included power cord and power supply The enclosed power supply has been approved for use by iSYSTEM.
-
Page 3: Table Of Contents
Contents Introduction ............................4 Options ..............................5 Operation ............................... 6 Mechanical information ........................ 7 BGA Assembly ............................. 8 Accessories ............................9 User Notes ............................10... -
Page 4: Introduction
Introduction Infineon TC397XE Compact Emulation Adapter is custom designed to achieve a minimum vertical size of the LQFP292 adaptation. It provides full trace capabilities for: TC397Xx · TC387QP · TC3E7Qx · microcontrollers where the trace port is not available or lacks the full trace capability. The Emulation Adapter might differ in some peripherals from the target device;... -
Page 5: Options
Options Target adaptation The Emulation Adapter adaptation to a specific target microcontroller pincount and package is done via a Solder part. Sometimes also an optional Extender is available. The optional Extender connects between the Emulation Adapter and the matching Solder part, which is being soldered on the embedded target side. -
Page 6: Operation
Operation Configuration J1: Target reset configuration Jumper J1 connects the Emulation Adapter reset line and the user target board reset line and is populated by default. J2: TP20_2/TESTMODEn configuration The TP20_2/TESTMODEn microcontroller pin is latched at power on reset release to enter test mode. Alternatively, it can operate as a general purpose I/O. -
Page 7: Mechanical Information
Mechanical information Emulation Adapter Top view of the Emulation Adapter Side view of the Emulation Adapter, one Extender and Solder part (each Extender adds approx. 3,25mm) Unit (mm) Ordering code IEA-TC397XE Compact 29.1 22.4 Extender Side view of the Extender Top view of the Extender Unit (mm) Ordering code... -
Page 8: Bga Assembly
BGA Assembly Watch out that the pin 1 position and alignment of all pins. Avoid disassembling and reassembling the hardware setup too frequently. 1. Solder the Solder part B on the Target A. Use the Surface Mount Technology (SMT) to solder the Solder parts to the target instead of the original microcontroller. -
Page 9: Accessories
Accessories To ease the development process, we recommend using the following iSYSTEM hardware tools. Ordering Code Description IC5700 iC5700 BlueBox On-Chip Analyzer IC57031 IOM6 Hub (3 x FNet & FBridge) IC57040 IOM6 CAN/LIN IC57041 IOM6 ADIO Active Probes and Converters Listed Active Probes and Converters provide tracing functionality. -
Page 10: User Notes
User Notes This page is intentionally left blank. - Page 11 This page is intentionally left blank.
- Page 12 Visit our website for: Support - isystem.com/support · Tutorials - isystem.com/getting-started · Knowledge Base - kb.isystem.com · www.isystem.com...