Table of Contents
Advertisement
USB Option
Safely Remove
Video wall settings
Access II Series LCD Panel User Guide
020-001836-01 Rev.1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Set to Off to disable the USB ports on the Display. Set this option as
5V to provide 5 volts power over USB. In this case, it is not available
to browse the USB content using the Media Browser feature of the
display.
Use this option to remove the devices connected to the USB inputs of
the Display safely. Highlight this option and press OK. Wait for the
message to be displayed on the screen indicating you can remove your
device and then remove your device. Failure to do so, may cause
problems when connecting the your USB device to other devices and
you may have to format your USB device.
Press OK to open the Video Wall Settings menu screen. Video Wall
Settings, Row Count, Column Count, Cell, and Offset options are
available.
Video Wall Settings: Enable or disable the Video Wall function by
pressing Left/Right directional buttons.
Row count: Adjust the number of Video Wall rows by pressing
Left/Right directional buttons. The maximum number that can
be set is 10.
Column count: Adjust the number of VideoWall columns by pressing
Left/Right directional buttons. The maximum number that can be
set is 10.
Cell: Each Video Wall unit is called Cell. Adjust the number of a cell by
pressing Left/Right directional buttons. The maximum number that
can be set is 100. To disable video wall function of the unit and
display the image in full-screen mode, the Cell option should
be set as 0.
Offset: Offset setting is used to adjust the refractions at the sides of
the picture depending on the bezel thickness between Video Wall units
(Cells). The maximum number that can be set is 50.
For example; For a 2x3 video wall matrix, Row count option should be
set as 2 and Column count option should be set as 3. Numbers of the
cells in a video wall matrix are determined as shown in the template
below. If setting the display, which is positioned same as the display
with the number 1 in this template, then the Cell option should be set
as 1 for this display.
1
4
Display panel menu contents
2
3
5
6
34
Advertisement
Table of Contents
