Christie UHD862-L User Manual page 33

Power Up Setting Menu
Power Up Mode
Quick Standy
Power on Delay
Auto Launch
Boot Up Picture Mode
HDMI1 Wake Up
HDMI2, HDMI3, HDMI4
Wake Up (Optional)
USB
Clone to USB
Clone From USB
Copy app cache from USB
USB Information
USB Operations
Access II Series LCD Panel User Guide
020-001836-01 Rev.1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Configures the power up mode preference. Last State, Always On and
Standby options are available.
If enabled, the display can be turned on again with the RS232 and
LAN commands if it is turned off through it. Press the left or right
buttons to enable or disable the feature.
Sets a delay value at power on. This value can be set from 0 to 2000 ms
in steps of 100 ms. The Display turns on after the set delay time is
expired.
Configures the auto launch preference. CMS(Start url), Open
Browser(Open Browser initial page), and Disabled options are
available.
Configures the picture mode preference at power on. If set as
Off the last set picture mode will be used at power on.
If set as Enabled, the display turns on with the HDMI1 input source,
when it is switched on. This feature works based on the HDMI 5V signal.
When this signal is active, the display wakes up and when the signal is
inactive the Display shuts down. Disable this option by setting as
Disabled. To use this feature in conjunction with the Auto Source Switch
Christie recommends enabling the Auto Source Switch option in the
Signage>Controls menu.
set
If any Scheduler is , this option is inactive and cannot be set as
Enabled. and can not be set as Enabled.
Note: This feature may not be available depending on the model
of your unit.
If is set as Enabled, the display turns on with the active input source
(HDMI2, HDM3 or HDMI4 depending on which input source is active), when
it is switched on.
Works based on the HDMI 5V signal. When this signal is active the display
wakes up and when the signal is inactive the Display shuts down. You can
disable this option by setting as Disabled. To use this feature in
conjunction with the Auto Source Switch feature, Christie recommends
enabling the Auto Source Switch option in the Signage>Controls
menu.
If any Scheduler is set this option is be inactive and can not be set as
Enabled.
Note: This feature or HDMI3 and HDMI4 options may not be
available depending on the model of your unit. If multiple devices are
connected to the display through HDMI input sockets, this feature
does not work.
Copies the database files from the unit to a connected USB device.
Copies the database files from a connected USB device to the unit.
Copies app cache data from a connected USB device to the unit.
Note: This feature may not be available depending on the model of your
unit.
Press OK to open the USB information menu screen. Current Total
space and Free space information of the connected USB device will be
displayed. You can also format the connected USB device using the
Format Disk option in this menu (FAT32 format only).
Highlight and press OK to perform USB operations
Display panel menu contents
33