Enabling Wake On Lan; Remotely Waking The Display Panel From Standby - Christie UHD862-L User Manual

The display panel supports 802.11 a,b,g and n type modems. Christie recommends using the IEEE
802.11n communication protocol.
The display panel cannot connect to networks with a hidden wireless network name (SSID). If the
modem shares the same SSID as another modem in the area, change the SSID of the modem. Use a
wired connection if you experience problems with a wireless connection.
1. Plug the Wi-Fi dongle into a USB port on the rear of the display panel.
2. On the display panel remote, press Menu.
3. Select System Settings > Network/Internet Settings > Network Type.
4. Select the Wireless device network connection.
The display scans for wireless networks automatically.
5. Select the network from the list.
6. If required, using the directional buttons on the remote, enter the network password and press
OK.
Alternatively, if the router has a WPS (Wi-Fi Protected Setup) button, select Press WPS on
your Wi-Fi router and press OK, and press the WPS button on the router.
When the IP address is displayed on the screen, the connection with the network has been
established.
7. If necessary, configure the network connection.
a) Select Advanced Settings and press OK.
b) Change the IP address setting to Manual and type the IP address for the display panel.
c) To save the settings, press OK.
d) Repeat steps 7b and 7c for the DNS settings.
8. To exit the menu, on the remote press Menu again.

Enabling Wake on LAN

Configure the display panel to accept Wake on LAN commands.
1. Disable Quick Standby.
a) On the remote, press Menu.
b) Navigate to Signage Settings > Power up settings > Quick Standby
c) Ensure Quick Standby is disabled.
2. Enable Wake on LAN.
a) Using a terminal program, access the display panel.
b) Run the following command: SWOL 1
c) To verify Wake on LAN is enabled, run the following command: GWOL

Remotely waking the display panel from standby

To remotely wake the display panel from standby, configure and use Wake on LAN software.
1. Download the Wake On LAN (WOL) software.
Free Wake On LAN software packages are available for downloading from the internet. The
steps below are for the Aquilia WOL software.
Access II Series LCD Panel User Guide
020-001836-01 Rev.1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Installing a display panel
20