Step 5: Disconnect The Access Point From The Administrative Computer; Step 6: Restore The Administrative Computer's Network Settings - Ruckus Wireless ZF7762-AC Installation Manual

Step 5: Disconnect the Access Point from the
Administrative Computer
1. Disconnect the AP from the power source (either from the AC power source or PoE
injector).
2. Verify that the PWR LED on the back of the AP is off.
3. Disconnect the Ethernet cable from the administrative computer's Ethernet port.
Step 6: Restore the Administrative Computer's Network
Settings
1. On your Windows XP or Windows 2000 computer, open the Network Connections (or
Network and Dial-up Connections) control panel according to how the Start menu is
set up:
• On Windows XP, click Start > Control Panel > Network Connections.
• On Windows 2000, click Start > Settings > Network Connections.
2. When the Network Connections window appears, right-click the icon for Local Area
Connection, and then click Properties.
3. When the Local Area Connection Properties dialog box appears, select Internet
Protocol (TCP/IP) from the scrolling list, and then click Properties. The TCP/IP
Properties dialog box appears.
4. Restore the computer's network settings by typing the original IP address settings in
the TCP/IP Properties dialog box.
5. On the TCP/IP Properties dialog box, click OK to close it.
6. Click OK again to close the Local Area Connection Properties dialog box.
You are now ready to connect the AP to your network.
Configuring for Standalone Operation or for Management by FlexMaster
Configuring the Access Point
31