Table of Contents
Advertisement
Before You Begin
Become Familiar with the Installation Components
Become Familiar with the Installation Components
The AP can be installed in an indoor or outdoor environment, such as an interior wall or
ceiling or the exterior roof overhang of a building or a streetlight pole. Refer to
for the components involved in a typical installation.
Take note of the components that must be installed indoor and outdoor. Ruckus Wireless
also strongly recommends that you form a drip loop on any cable that is connected to
devices that are installed outdoor (for example, the AP).
NOTE: The AP only requires one power source (either AC or PoE). The diagram below
shows both power sources to illustrate how each power source is typically connected if
used in the deployment.
Figure 7.
Typical installation components
Router or switch
WARNING: Only trained and qualified personnel should be allowed to install, replace,
or service this equipment.
WARNING: Installation of this equipment must comply with local and national electrical
codes.
12
INDOOR
PoE injector
OUTDOOR
AC cable
ZoneFlex 7762 AC
Outdoor AP
Figure 7
AC power
source
Ground
screw
18 AWG min
green-and-yellow
wire
Advertisement
Table of Contents
