Table of Contents
Advertisement
Preparing for Installation
Pointing the CMAP to ZoneDirector
Step 5: Disconnect the CMAP from the Administrative
Computer
1. Disconnect the CMAP from the DC power source.
2. Verify that all LEDs are off.
3. Disconnect the Ethernet cable from the administrative computer's Ethernet port.
Step 6: Restore the Administrative Computer's Network
Settings
1. On your Windows XP or Windows 2000 computer, open the Network Connections (or
Network and Dial-up Connections) control panel according to how the Start menu is
set up:
•
On Windows XP, click Start > Control Panel > Network Connections.
•
On Windows 2000, click Start > Settings > Network Connections.
2. When the Network Connections window appears, right-click the icon for Local Area
Connection, and then click Properties.
3. When the Local Area Connection Properties dialog box appears, select Internet
Protocol (TCP/IP) from the scrolling list, and then click Properties. The TCP/IP
Properties dialog box appears.
4. Restore the computer's network settings by typing the original IP address settings in
the TCP/IP Properties dialog box.
5. On the TCP/IP Properties dialog box, click OK to close it.
6. Click OK again to close the Local Area Connection Properties dialog box.
You are now ready to connect the CMAP to your network.
Pointing the CMAP to ZoneDirector
If you are deploying the access point to be managed by ZoneDirector, you must ensure
that the CMAP can report to its parent ZoneDirector device on the network. There are two
ways you can do this:
Use SSH to Set the ZoneDirector IP Address on the CMAP
■
Configure Option 43 on the DHCP Server (ZoneDirector Management Only)
■
14
Advertisement
Table of Contents
