Operation
CAUTION – PROPERTY DAMAGE!
►
If you are not sure whether the floor is suitable for cleaning, please carry
out a tolerance test using a concealed part of the floor .
►
Always comply with the cleaning instructions of the carpet manufacturer .
Before cleaning, check also whether the carpet is suitable for steam clean-
ing .
►
Never use the appliance without a pad 6/o on the steam foot 5 .
Otherwise the floor could get scratched!
►
Never operate the appliance without water in the water tank 8!
The pump could overheat and be damaged!
NOTE
►
Before you clean the floor with the steam mop, we recommend that you
vacuum the floor to remove any loose particles of dirt .
Once the appliance is assembled and filled with water:
1) Press and hold in the "Handle" release button 1 and flip the handle up-
wards so that it clicks into place .
2) If not already done: Completely unwind the power cable from the cable
hooks z/i . To facilitate the unwinding of the cable, you can flip down the
upper cable hook z by pulling it out a little and turning it at the same time .
3) Run the cable through the notch t on the rear of the handle so that the
cable does not hang down into the working area .
4) Insert the plug into the mains power socket .
5) Set the on/off switch u to "I" . The on/off switch u lights up, the red
POWER control lamp 0 flashes .
6) Use the MODE button e to select the desired level of steam generation:
–
Press 1 x: low steam level, green control lamp w lights up .
–
Press 2 x: high steam level, red control lamp q lights up .
–
Press 3 x: no steam, standby, POWER control lamp 0 lights up .
NOTE
►
We recommend the high steam level especially for moisture- and heat-
resistant floor coverings, such as tiles .
►
We recommend the low steam level especially for moisture- and heat-
sensitive floor coverings, such as parquet flooring .
7) Wait around 30 seconds while the appliance heats up .
8) Press the "Steam" button r . The appliance starts generating steam and,
after a short time, steam is emitted through the pad 6/o .
■
10
│
GB │ IE │ NI │ CY
SDM 1500 C2