Nortel Meridian 1 Option 11C Upgrade Manual page 139

Assign TDS/DTR, XTD, and SDI functions
4 Configure the eight DTR units on the SSC card using LD 13 (see
Table 16).
Make sure you configure all eight units.
Note: You must configure the TDS loop in LD 17 before performing
this step.
Table 16
LD 13 - Configure DTR units on SSC card.
Prompt Response
REQ NEW
TYPE DTR
TN c u
5 Remove the TDS function using LD 17.
To remove the TDS function, follow the instructions in Table 17.
Note: This step fails if you do not first disable the TDS in LD 34 (see
Step 1 on page 138). This step also fails if you do not first remove
DTRs from the TDS/DTR slot.
Table 17
LD 17 - Remove TDS.
Prompt Response
REQ CHG
TYPE CFN
CEQU YES
TDS Xn
6 Enable the NTAK03 TDS/DTR to use the SDI port.
7 Enable the TDS/DTRs on the SSC card in LD 34. Use the "ENLX 0"
command.
8 Perform an EDD backup in LD 43.
—————————— End of Procedure ——————————
Option 11C and 11C Mini
Page 139 of 224
Comments
Add information.
Digitone receivers data block.
c = 0
u = 0 to 7 (Repeat until you
configure all eight units.)
Comments
Change.
Configuration data block.
For changes to common
equipment
n = 1 to 9 (TDS card slot
location)
Put an X before to remove
Upgrade Procedures Guide