Nortel Meridian 1 Option 11C Upgrade Manual page 133

Assign TDS/DTR, XTD, and SDI functions
4 Configure TDS on the SSC card using LD 17 (shown in Table 5).
Table 5
LD 17 - Configure TDS on SSC card.
Prompt Response
REQ CHG
TYPE CFN
CEQU YES
TDS 0
5 Remove the eight DTR units on the TDS/DTR card using LD 13
(shown in Table 6).
Make sure you remove all eight units.
Table 6
LD 13 - Remove DTR units on the TDS/DTR card.
Prompt Response
REQ OUT
TYPE DTR
TN c u
6 Configure the eight DTR units on the SSC card using LD 13
(shown in Table 7).
Make sure you configure all eight units.
Table 7
LD 13 - Configure DTR units on the SSC card.
Prompt Response
REQ NEW
TYPE DTR
TN c u
Option 11C and 11C Mini
Page 133 of 224
Comments
Change.
Configuration data block.
For changes to common
equipment
Tone and Digit switch for the
NTDK20 SSC card.
Comments
Remove information
Digitone receivers data block
c = card slot of the TDS/DTR
card
u = 0 to 7 (Repeat until you
remove all eight units.)
Comments
Add information
Digitone Receivers data block
c = 0
u = 0 to 7 (Repeat until you
configure all eight units.)
Upgrade Procedures Guide