Table of Contents
Advertisement
•
Sr. Pan tilt head is now properly mounted on
the tilt head section as shown in the image.
•
Mount your camera
(Not Included)
mounting plate of Sr. Pan Tilt Head.
•
Insert the check nut through the bottom of the
head and secure the camera with the help of
an Allen key.
•
Camera is properly secured with head section
as shown in the image.
Joystick Controller Setup
•
Install your cable starting at the camera end
and making sure to leave enough slack for
full pan and tilt movements.
•
Connect 15mtr control cable with motor
cable as shown in the image.
The Pan Tilt Head circuitry is built entirely into the Joystick Controller. The only requirement is AC
adapter (Included) or Battery Power (Not included). The AC adapter can handle 100-240 volts. Users will
need the appropriate plug adapter for local use.
•
Then connect the other cable to the main
cable port on the joystick controller.
•
Install 12 volt AC adapter (4 pin XLR) in the
socket of Joystick Box.
NOTE: Any 12 volt battery may operate this
Pan Tilt Head as long as the Connector and the
#1 Negative pin & #4 Positive pin of Cable
meet together.
on camera
16
Advertisement
Table of Contents
