Advertisement
Quick Links
7' WAVE-2 VIDEO JIB CRANE With CST-
100 Stand & portable Dolly
(P-WV-2SD)
I N S T R U C T I O N M A N U A L
All rights reserved
No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any
means, electronic, mechanical, photocopying, recording, or otherwise, except as may be expressly permitted
by the applicable copyright statutes or in writing by the publisher.
Advertisement
Related Manuals for PROAIM P-WV-2SD
Summary of Contents for PROAIM P-WV-2SD
- Page 1 7’ WAVE-2 VIDEO JIB CRANE With CST- 100 Stand & portable Dolly (P-WV-2SD) I N S T R U C T I O N M A N U A L All rights reserved No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, except as may be expressly permitted by the applicable copyright statutes or in writing by the publisher.
-
Page 2: Contents Of Shipping Box
The padded shipping /storage container has been especially designed to protect your purchase while in transit and is a good place to keep your PROAIM 7' Wave-2 Video Jib Crane with CST-100 Stand and portable Dolly when not in use. - Page 3 Proaim 7’ WAVE-2 VIDEO JIB CRANE With CST-100 Stand & portable Dolly ASSEMBLING YOUR PROAIM 7' WAVE JIB WITH 100MM TRIPOD STAND AND SPREADER Take out the spreader and open it’s legs as shown in the image. Position the height of the tripod by loosening all three adjustment knobs, sliding the tripod up to the desired height and re-tighten the knobs securely.
- Page 4 Proaim 7’ WAVE-2 VIDEO JIB CRANE With CST-100 Stand & portable Dolly Unscrew the locking lever from the Central Post of the jib. Place the Central Post in the bowl of Tripod Stand and re-tighten the locking mechanism for a secure fit. (as shown in the picture.)
- Page 5 Proaim 7’ WAVE-2 VIDEO JIB CRANE With CST-100 Stand & portable Dolly Then, loosen the knob provided at the lower telescopic section of the jib arm as shown in the picture to extend the front section of the telescopic jib accordingly to the rear section.
- Page 6 Proaim 7’ WAVE-2 VIDEO JIB CRANE With CST-100 Stand & portable Dolly YOUR PROAIM 7’ WAVE DSLR VIDEO JIB ARM WITH TRIPOD STAND ALL SET AND READY TO USE (SHOWN WITH OTPIONAL ACCESSORIES) NOTE: Add weights to the rear of jib corresponding to the weight of camera attached to balance the jib arm.
-
Page 7: Warranty
Proaim 7’ WAVE-2 VIDEO JIB CRANE With CST-100 Stand & portable Dolly Position the height of the tripod by loosening all three adjustment knobs, sliding the tripod up to the desired height and re-tighten the knobs securely. Now, place the tripod foot on the dolly and tie down it with the help of elastic clip downs as shown in the picture. - Page 8 Proaim 7’ WAVE-2 VIDEO JIB CRANE With CST-100 Stand & portable Dolly the complete cost of sending replacement parts within the warranty period. After that, Nominal cost of the product & Actual shipping cost will be charged. Do not send the unit to us without first getting a response and getting the approval to send back the item.