FUNCTION ELECTRONIC BOARD REPLACEMENT
NOTE
It is not necessary to perform the electronic programming of the new board.
1.
Position the machine on a level ground.
2.
Turn the ignition key (10) to "0" position.
3.
Disconnect the battery connector (40).
4.
Pull the handle out (63) from the squeegee lifting lever.
5.
Remove the screws (64) and carefully move the cover (57) moving as necessary the rubber panel (A).
6.
Disconnect the electrical connections (B) of the function electronic board (C) (See the wiring diagram).
7.
Remove the screws (D) and the function electronic board (C).
8.
Reassemble by carrying out the disassembly operations in the reverse order, with the following caution:
–
set the new electric board as follow;
–
according to battery type (75), place the selector (52) on "WET" for lead batteries or on "GEL" for gel batteries.
909 5484 000(1)2004-03
Figure 2
SERVICE MANUAL
S300648
47