Nilfisk-Advance BA 600S Service Manual page 6

Table of Contents

Advertisement

WARNING!
Carefully read all maintenance/repair instructions before performing any maintenance/repair
procedure.
Before using the battery charger apparatus, ensure that frequency and voltage values, indicated
in the machine serial number plate, match the mains voltage.
Take all necessary precautions to prevent hair, jewels and loose clothes from being caught by the
machine moving and vacuum parts.
Do not smoke during battery charging.
Before leaving the machine unattended, make sure that the machine cannot move and remove the
ignition key.
Do not use the machine on surfaces with a gradient greater than the one indicated on the
machine.
Do not wash the machine with direct or pressurized water jets, or with corrosive substances.
Do not use the machine in particularly dusty areas.
While using this machine, take care not to cause damage to other people.
The storage temperature must be between +32°F and +104°F (0°C and +40°C).
The machine operating temperature must be between +32°F and 104°F (0°C and +40°C).
Humidity must be between 30% and 95%.
Always protect the machine from the sun, rain and bad weather, when it is both in the operating
and stationary state.
Do not use the machine as a means of transport.
Do not use the machine on ramps or slopes with an inclination higher than 2%.
Do not allow the brush to operate while the machine is stationary to avoid damaging the floor.
In case of fire, possibly use a powder fire extinguisher, not a water fire extinguisher.
Do not bump into shelves or scaffoldings, particularly where there is a risk of falling objects.
Do not remove or modify the plates affixed to the machine.
If parts must be replaced, contact an Authorized Dealer or Retailer for ORIGINAL spare parts.
The machine must be disposed of properly, because of the presence of toxic-harmful materials
(batteries, etc.), which are subject to standards that require disposal in special centers (see
chapter "Scrapping").
Do not let any object enter the openings. Do not use the machine in case the openings are
clogged; always keep the openings free from dust, hairs and any other foreign material which
could reduce the air flow.
This machine cannot be used on public roads or streets.
Pay attention during the machine transfers when temperature is below the freezing point. The
water in the recycling tank or in the pipes could freeze and seriously damage the machine.
Only use the brushes and pads/cylindrical brushes supplied with the machine and those
specified in the Instruction Manuals. Using other brushes or pads/cylindrical brushes could
reduce safety.
909 5484 000(1)2004-03
SERVICE MANUAL
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ba 650sBa 750s

Table of Contents