Table of Contents
Advertisement
SERVICE MANUAL
VACUUM MOTOR DISASSEMBLY
1.
Drain the recycling water, if any, from the related tank (70) by using the pipe (36).
2.
Drain the solution, if any, from the related tank (71) by using the pipe (37).
3.
Position the machine on a level ground.
4.
Turn the ignition key (10) to "0" position.
5.
Disconnect the battery connector (40).
6.
Unscrew the handwheel (66).
7.
Hold the handlebar (2) and carefully lift the tank assembly (78) to be able to work on the deck (79).
8.
Remove the acoustic insulation assembly (A).
9.
Remove the acoustic insulation assembly (B).
10. Disconnect the vacuum motor (D) connector (C).
11. Loosen the clamp (E) and remove the hose (F).
12. Unscrew the handwheels (G) and remove the vacuum motor (D).
13. Reassemble by carrying out the disassembly operations in the reverse order, paying attention to what follows:
–
when a new motor is installed, it is necessary to reuse the protection net (H) and install it on the new motor
with a new gasket (I).
36
Figure 4
S300638
909 5484 000(1)2004-03
Advertisement
Table of Contents
Troubleshooting
