Electrical System; Battery Removal; Battery Maintenance And Recharging; Drive Electronic Board Replacement - Nilfisk-Advance BA 600S Service Manual

SERVICE MANUAL

ELECTRICAL SYSTEM

ELECTRICAL SYSTEM

BATTERY REMOVAL

1. Drain the recycling water, if any, from the related tank (70) by using the pipe (36).
2. Drain the solution, if any, from the related tank (71) by using the pipe (37).
3. Position the machine on a level ground.
4. Turn the ignition key (10) to "0" position.
5. Disconnect the battery connector (40).
6. Unscrew the handwheel (66).
7. Hold the handlebar (2) and carefully lift the tank assembly (78) to be able to work on the battery.
8. Disconnect the battery cables.
9. Remove the batteries (75).
10. If necessary, remove the battery frame (89).
11. Reassemble by carrying out the disassembly operations in the reverse order.

BATTERY MAINTENANCE AND RECHARGING

See Use and Maintenance Manual

DRIVE ELECTRONIC BOARD REPLACEMENT

NOTE
It is not necessary to perform the electronic programming of the new board.
1. Position the machine on a level ground.
2. Turn the ignition key (10) to "0" position.
3. Disconnect the battery connector (40).
4. Pull the handle out (63) from the squeegee lifting lever.
5. Remove the screws (64) and carefully move the cover (57) moving as necessary the rubber panel (A).
6. Disconnect the electrical connections (B) of the drive electronic board (C) (See the wiring diagram).
7. Remove the screws (D) and the drive electronic board (C).
8. Reassemble by carrying out the disassembly operations in the reverse order.
46
Figure 1
S300647
909 5484 000(1)2004-03