Extrapressure Deck Position Inspection; Reassembly - Nilfisk-Advance BA 600S Service Manual

Extrapressure deck position inspection

14. Turn the ignition key (10) to "I" position and lower the brush deck (22) in the extrapressure position by using the
switch (3). Turn the ignition key (10) to "0" position.
15. When the brush deck (A) is lowered in the extrapressure position, check that the lever (J) is at about 20-25 mm from
the stop (K), as shown in the figure. If necessary, restore this condition by proceeding as follows.
16. Unscrew the screws (D) and remove the cover (E) with the gasket (F), if you haven't done it yet.
Loosen the cam dowel (Q) and rotate the cam by varying the microswitch (R) actuation point as necessary; tighten
the cam dowel.
Turn the ignition key (10) to "I" position and lift and lower the brush deck (A) in the extrapressure position by using
the switch (3), then turn the ignition key (10) to "0" position and repeat the inspection described at step 15.
NOTE
If necessary, the actuator limit switch positions can also be adjusted at the workbench; see the
procedure in the relevant paragraph.

Reassembly

17. Position the cover (E) with the gasket (F) into its seat, then tighten the screws (D).
18. Carry out steps from 1 to 7 in the reverse order.
909 5484 000(1)2004-03
SERVICE MANUAL
27