Table of Contents
Advertisement
Programming
PROGRAMMING
1=FACP CONFIG USER
2=INPUT ZONES
3=OUTPUT CIRCUITS
Programming Screen #1
50
3.5.1 FACP CONFIG (Application Templates)
For a detailed description of each Template, refer to "FACP Configuration Templates" on page
108. The FACP Configuration option allows the user to program the FACP with one of two factory
preprogrammed templates or one custom template which can be programmed by the user. The
templates have been provided to allow the user to quickly program the panel with typical job-site
configurations. The user may choose to select one of the templates or bypass this option,
proceeding to the next sections which detail customized programming of the FACP.
A factory template may be chosen and later changed to better fit a site requirement. The changed
template can be saved as the one custom template.
Pressing 1, while viewing Programming Screen #1, will select the FACP Config option and display
the following screen:
1=TEMPLATE 1
2=TEMPLATE 2
3=N/A
Press the down arrow key to view all available templates. During initialization of the panel
following power-up or reset, the selected Template will be displayed by the LCD.
Note: Only Template 1 and Template 2 as well as the Custom Template are available for the MRP-
2002/E Agent Release Control Panel.
To select a pre-programmed template, press the number key corresponding to the desired template.
Note that the factory templates may pre-set most programmable features of the FACP.
3.5.2 Input Zones
The Input Zones option allows the user to initially program or change the programming for the six
input zones (circuits). Pressing 2, while viewing Programming Screen #1, will select the Input
Zones option and display a screen similar to the following:
1=ZONE 1
2=ZONE 2
3=ZONE 3
Pressing the down arrow key will display additional screens for Input Zones 4 through 6. To
program a specific zone, press the number key corresponding to the desired zone while viewing one
of the Input Zone screens.
To program Input Zone 1, press the 1 key while viewing Input Zone Screen #1. The following
screens will be displayed:
Normal 2-WIRE SMOKE
FACP CONFIG
FACP Config Screen #1
INPUT ZONES
Input Zone Screen #1
INPUT ZONE 1
PRESS
TO EDIT
Edit Input Zone Screen #1
Master Programming Level
MRP-2002 & MRP-2002E PN 53049:A1 5/01/2008
Advertisement
Table of Contents
