Operating Instructions
Pressing 2 allows the user to print the Walktest log which will detail all of the system activations
during walktest since the log was last cleared. Refer to "Walktest" on page 79 for additional
information on the display.
Pressing 3 will exit the Print operation.
4.15.11 ANN-BUS
Pressing 2 while viewing Read Status Screen #4 will display the settings for the ANN-BUS options
as shown in the following screens:
ANN-BUS Screen #1 indicates whether the ANN-BUS is enabled (Yes/No).
Pressing 1 while viewing ANN-BUS Screen #1 will display BUS Module addresses 1-8 and the
devices, if any, located at those addresses.
Pressing 2 while viewing ANN-BUS Screen #1 will display the programmed options for the ANN-
S/PG Module devices connected to the ANN-BUS.
Pressing 1 while viewing ANN-BUS Screen #2 will display the programmed options for the ANN-
I/O Module devices connected to the ANN-BUS.
Pressing 2 while viewing ANN-BUS Screen #2 will display the programmed options for the ANN-
80 LCD annunciators connected to the ANN-BUS.
Pressing 3 while viewing ANN-BUS Screen #2 will display the programmed options for the ANN-
RLY devices connected to the ANN-BUS.
Pressing 1 while viewing ANN-BUS Screen #3 will display the programmed options for the ANN-
LED devices connected to the ANN-BUS.
98
ANN-BUS
BUS ENABLED
1=BUS MODULES
2=ANN-S/PG OPTIONS
ANN-BUS Screen #1
ANN-BUS
1=ANN-I/O OPTIONS
2=ANN-80 OPTION
3=ANN-RLY OPTIONS
ANN-BUS Screen #2
ANN-BUS
1=ANN-LED OPTIONS
ANN-BUS Screen #3
NO
MRP-2002 & MRP-2002E PN 53049:A1 5/01/2008
Read Status