Table of Contents
Advertisement
Appendix C: Software Installation Instructions
Initializing Disk Drives
If an installed disk does not appear in the disk selection list for creating a new
array, or if it appears grayed out, you may have to initialize it before you can use
it as part of an array. Drives attached to the controller must be initialized before
they can be used in an array.
Caution: Initializing a disk overwrites the partition table on the disk and makes
any data on the disk inaccessible. If the drive is used in an array, you may not be
able to use the array again.
Do not initialize a disk that is part of a boot array. To determine which disks are
associated with a particular array, please refer to
Viewing Array Properties.
To initialize drives:
1. Turn on your computer and press Ctrl+A when prompted to access the ARC
utility.
2. From the ARC menu, select Array Confi guration Utility (ACU) (as shown in the
screen below).
3. Select Initialize Drives (as shown in the screen below).
C-11
Advertisement
Table of Contents
