Table of Contents
Advertisement
X6DVA-4G2/X6DVA-EG2 User's Manual
Remote Access Confi guration
You can use this screen to select options for the Remote Access Confi guration.
Use the up and down arrow keys to select an item. Use the <+> and <-> keys to
change the value of the selected option.
Remote Access
This feature allows the user to disable the function of Remote Access. If Disabled
is not selected, then you can select a Remote Access type. The options are
Enabled and Disabled.
Remote Access
This feature allows the user to enable the function of Remote Access. The Options
are Enabled and Disabled.
If the item "Remote Access" is set to Enabled, you can select a Remote Access
type and confi gure the following settings:
Serial Port Number
This feature allows the user to select the serial port for Console Redirection.
The options are COM1 and COM2.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection.
The options are 115200 8, N, 1, 57600 8, N, 1, 38400 8, N, 1, 19200 8, N, 1
and 9600 8, N, 1.
Flow Control
This feature allows the user to set the fl ow control for Console Redirection.
The options are None, Hardware, and Software.
Redirection After BIOS POST
Select Disabled to turn off Console Redirection after POST. Select Always
to keep Console Redirection active all the time. (Note: this setting may not be
supported by some operating systems.) Select Boot Loader to keep Console
Redirection active during POST and Boot Loader.
Terminal Type
This feature allows the user to select the target terminal type for Console
Redirection.The options are ANSI, VT100, and VT-UTF8.
VT-UTF8 Comb Key Support
Select Enabled to enable the VT-UTF8 Combination Key support for the
ANSI/VT100 Terminals. The options are Enabled and Disabled.
4-14
Advertisement
Table of Contents
