Power Fault - Supermicro X6DVA-4G2 User Manual

VGA Connector
A VGA connector (J1) is located next
to the GLAN1 on the IO backplane.
Refer to the board layout below for
the location.

Power Fault

Connect a cable from your power
supply to the PW4 header to provide
warning of power supply failure. This
warning signal is passed through the
PWR_LED pin to indicate of a power
failure on the chassis. See the table
on the right for pin defi nitions.
VGA
PW1
Battery
GLAN1
GLAN2
Note: This feature is only available when using
redundant Supermicro power supplies.
PWR Fault
8-pin
PW3
PWR
2-17
Chapter 2: Installation
PWR Fail
Pin Defi nitions
Pin# Defi nition
1 PWR 1 Fail Signal
2 PWR 2 Fail Signal
3 PWR 3 Fail Signal
4 PWR 4 Fail Signal