Power Force-On; Alarm Reset - Supermicro X6DVA-4G2 User Manual

Power Force-On

Jumper JPF allows you to enable or dis-
able the function of Power Force-On. If
enabled, the power will always stay on
automatically. If this function disabled,
the user needs to press the power but-
ton to power on the system.

Alarm Reset

The system will notify you in the event
of a power supply failure. This feature
assumes that Supermicro redundant
power supply units are installed in the
chassis. If you only have a single power
supply installed, you should not connect
anything to this header (JPR1) to pre-
vent false alarms. See the table on the
right for jumper settings.
Alarm Reset PWR Force-On
PW1
Battery
GLAN1
GLAN2
8-pin
PW3
PWR
2-23
Chapter 2: Installation
Power Force-On
Jumper Settings
Jumper Setting Defi nition
Off Normal
On Force-On
Alarm Reset
Jumper Settings
Jumper Setting Defi nition
Open Enabled
Closed Disabled