VGA Enable/Disable
JPG1 enables or disables the VGA
Connector on the motherboard. See
the table on the right for jumper set-
tings. The default setting is enabled.
SMB Data/SMB CLK to PCI
Jumpers J13, J15 allow you to connect
PCI Slot1/PCI-X Slot5/PCI -X Slot6
to the System Management Bus
default setting is to close pins 1-2 to
enable the connection. See the table
on the right for jumper settings.
J15
J13
VGA Enable
8-pin
PWR
PW1
Battery
GLAN1
GLAN2
.
The
PW3
2-21
Chapter 2: Installation
VGA Enable/Disable
Jumper Settings
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
SMBus to PCI/PCI/Exp
Jumper Settings
Jumper Setting
Defi nition
Closed
Enabled
Open
Disabled (*Default)