Gb Lan Enable/Disable; Vga Enable/Disable; Power Supply Alarm Enable/Disable; Scsi Enable/Disable - Supermicro SUPER X5DPL-8GM User Manual

Gb LAN Enable/Disable

Use jumper JD3 to enable or dis-
able the Gb LAN port on the
motherboard (see Figure 2-3 for
location.) Refer to the table on the
right for jumper settings. The de-
fault setting is enabled.

VGA Enable/Disable

JP4 allows you to enable or disable
the VGA port. The default position
is on pins 1 and 2 to enable VGA.
See the table on the right for
jumper settings.
Power Supply Alarm
Enable/Disable (JP9) &
(JP36)
Alarm Reset
The system will notify you in the
event of a power supply failure.
This feature
Supermicro redundant power sup-
ply units are installed in the chas-
sis. If you only have a single
power supply installed, you should
disable this (the default setting)
with JP9 to prevent false alarms.
See the table on the right for
jumper settings.

SCSI Enable/Disable

(X5DPL-8GM)
Use the SCSI termination jumper at
JP22 to enable or disable the
onboard SCSI controller. The nor-
mal (default) position is on pins 1-
2 (enabled). See the table on the
right for jumper settings.
assumes that
2-15
Chapter 2: Installation
Gb LAN
Enable/Disable
Jumper Settings
(JD3)
Jumper
Position Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
VGA Enable/Disable
Jumper Settings
(JP4)
Jumper
Position Definition
1-2 Enabled
2-3 Disabled
Power Supply
Alarm Enable/Disable
Jumper Settings (JP9)
Jumper
Definition
Position
Open
Disabled
Closed Enabled
3rd Party PW Fail Alarm
Reset Jumper Settings
(JP36)
Jumper
Position Definition
Open Enabled
Closed Disabled
SCSI Enable/Disable
Jumper Settings
(JP22)
Jumper
Position Definition
Pins 1-2 Enabled
Pins 2-3 Disabled