Adjusting The End Stop; Overriding Controlled Dual Stacking; Dual Stacking Toggle Patch - Kodak i5 50 Series User Manual

Adjusting the end stop

Overriding Controlled Dual
Stacking

Dual Stacking Toggle Patch

82
You can also adjust the end stop. It is recommended that the end stop be
adjusted about 1.5 inches (38.1 mm) longer than the longest document that
will be deposited into Stack #2. Use the thumbscrews on the bottom of Stack
#1 to make adjustments.
1. Loosen both screws on the bottom of Stack #1.
2. Slide the end stop in or out to the desired length.
3. Tighten both screws.
Controlled Dual Stacking can be overridden by using the Overrides screen on
the Operator Control Panel. See "Overrides" on page 49 for more information.
Dual Stacking Toggle Patch can be enabled from the Operator Control Panel.
The Dual Stacking Toggle Patch option allows you to use patch sheets when
you are preparing your documents to automatically separate exception
document(s) from the stack. This option allows you to separate exception
document(s) by having a patch sheet before and after the exception
document(s).
Rear Patch Sorting must be enabled on the Operator Control Panel for the
patches to go to the Rear Exit tray and the exception document(s) to go to the
designated exception tray.
A-61868 November 2016