Kodak i5 50 Series User Manual page 120

106
5. With one hand, press the locking tabs (one on each side) while holding the
lower housing with the other hand. Pull the upper housing up and away
from the rollers.
6. Remove both rollers.
7. Remove each tire by sliding the tire off the core assembly.
8. Install each new tire by gently pulling it over the core assembly. The tires
do not need to be installed in any specific orientation.
IMPORTANT:Do not overstretch the tire; it may tear.
9. Replace each roller in the lower feed module housing and align the tabs on
the upper housing with the slots on the lower housing.
10. Press the upper and lower housings together until they snap into place.
Core assembly
A-61868 November 2016