Table of Contents
Advertisement
Controlled Dual
Stacking Accessory
(not available with i5650S
or i5850S)
1
1 exit tray with extendable end stop
2
2 magnetic sides guides for Stack #1
3
2 magnetic side guides for Stack #2
4
1 short document insert
5
2 magnetic short document side guides
6
1 extender insert Stack #1
7
1 alternate end stop extension
Stacking locations
A-61868 November 2016
This accessory allows physical stacking of the scanned documents based on
document size or a patch code. This accessory also has the ability to choose
the stacking location of a document that triggers a multifeed event.
Refer to the Scanning Setup Guides for TWAIN and ISIS on the CD/DVD or
your scanning application documentation for more information about enabling
and setting up your scanner for using controlled dual stacking.
Use the guide below to help you locate parts when you are adjusting and using
the Dual Controlled Stacking Accessory.
The Controlled Dual Stacking Accessory is designed to replace the standard
exit tray on the i5x50 Scanners. The Controlled Dual Stacking Accessory has
two stacking locations — Stack #1 and Stack #2.
Stack #1: is located closest to the top of the document transport where the
document exits the scanner. This location is typically used as the exception
stack when you want to separate shorter documents (less than 6 inches) from
a document set.
Stack #2: is the lower location and is typically used as the exception stack
when you want to separate patch pages from a document stack or separate a
multifed document.
Stack #1
Stack #2
77
Advertisement
Table of Contents
