Sorting And Stacking; Adjusting Output Trays For The I5650S And I5850S Scanners - Kodak i5 50 Series User Manual

5 Sorting and Stacking

Adjusting output
trays for the i5650S
and i5850S Scanners
A-61868 November 2016
This chapter provides information for using:
• Sorter capabilities and trays for the i5650S and i5850S Scanners.
• The Rear Patch Sorting Option for the i5650S and i5850S Scanners.
• The optional Kodak Controlled Dual Stacking Accessory for the Kodak i5850
Scanner only. To use the stacking option you must have purchased this
accessory and the feature must be enabled by a qualified Service
Representative.
The scanner's output trays can be adjusted to meet your scanning/sorting
needs for documents up to 17 inches long. You may need to remove and
reinsert the trays for adjustment or maintenance.
The documents to be specially identified (sorted/stacked) are called the
exception documents. The TWAIN Datasource, ISIS Driver or your scanning
application provides options on how you want to output your documents (e.g.,
based on size, patch sheets or multifeeds) by using the Sorting/Stacking option
and allowing for the exception documents to be sorted to either the Lower
output tray (Tray 1) or the Upper output tray (Tray 2).
• Tray 1/Lower tray: is the lower location where the document exits the
scanner. This location allows for the largest number of documents in the
output tray. It can be used for either the exception documents or the non-
exception documents. If the majority of the documents being scanned are
exception documents, then the lower output tray should be selected for the
exception tray. Documents will be output in this tray if you do not have any
document sorting/stacking options selected in your scanning application. If
you need to remove or adjust this tray, see "Adjusting the output tray" on
page 19.
71