Table of Contents
Advertisement
Installing the optional
document extender
Adjusting the output tray
A-61868 November 2016
• If you are scanning documents longer than 43.2 cm (17 inches), the
scanning application must be set to accommodate these long
documents. Be sure to verify that the Maximum Length option on the
Device-General tab (TWAIN Datasource) or the Longest Document
option on the Scanner tab (ISIS Driver) is set to slightly longer than the
longest document being scanned. Setting a length longer than needed
may impact throughput.
• For i5250V and i5650V Scanners: these scanners have a set
maximum Document Length of 40 inches; therefore, no adjustment is
necessary.
• It is recommended that you use a document extender if you are
scanning documents longer than 43.2 cm (17 inches). Three sizes of
document extenders are available for scanning documents from
43.2 cm (17 inches) to 86.36 cm (34 inches). See "Supplies and
consumables" on page 112 for ordering information.
• Document weights — the maximum document weight for the input
elevator is the approximate weight of a 500-sheet ream of A3 (11 x 17-
inch) paper or a 750-sheet ream of A4 (8.5 x 11) paper. If you are
scanning documents larger than A3 (11 x 17-inch), the recommended
weight capacity should not exceed 4.5 kg (10 pounds). If the documents
you are scanning are larger than A3 (11 x 17-inch), scan fewer than 100
sheets at a time.
• Insert the ends of the document extender into the holes on the input elevator
and the output tray and lower the extender into position.
Various document handling settings are available to adjust the way that
documents are placed into the output tray (via the TWAIN Datasource, ISIS
Driver or VRS). The highest throughput can be obtained by scanning
documents of similar size using the output tray side guides and end stop with
Normal document handling.
Other document handling options are available for better handling when
scanning documents of varying size and thickness.
19
Advertisement
Table of Contents
