Adjusting The Output Tray; Closing The Input And Output Trays; Installing Optional Accessories - Kodak i250 User Manual

Adjusting the Output Tray

Closing the Input and
Output Trays
Installing Optional
Accessories
16
The output tray has three positions.
Lowest position for
long documents
• Set the output tray to the lowest position when you are scanning
long documents.
• Set the output tray to the middle position when you are scanning letter-
or A4-size documents.
• Set the output tray to the highest position with the first document stop when
you are scanning checks.
Use the highest position with the second document stop raised when you
are scanning documents that are 14 cm (5.5 in.) long.
1. Grasp the tray on each side.
2. Lift up the tray and move it up or down to the desired position.
You can move the scanner trays out of the way when the scanner is not in use.
1. Grasp the input tray.
2. Lift up the input tray until it rests against the scanner front.
3. Grasp the output tray.
4. Lift up the output tray until it rests against the scanner back.
If you have purchased a KODAK i200 Series Imprinter, KODAK i200 Series
Dockable Flatbed, and/or additional memory (SODIMM), refer to the appropriate
appendix in this guide for installation instructions for the accessory.
Middle position for
letter or A4 documents
Highest position
for checks
A-61167 September 2002