Installing Dimms - Supermicro X5DEE-M User Manual

2-3

Installing DIMMs

Note: Check the Supermicro web site for recommended memory modules:
http://www.supermicro.com/TECHSUPPORT/FAQs/Memory_vendors.htm
Exercise extreme care when installing or removing DIMM modules
DIMM Installation (See Figure 2-2)
1. Insert the desired number of DIMMs into the memory slots, starting with Bank
1.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to prevent inserting the DIMM module incor-
rectly.
3. Gently press down on the DIMM module until it snaps into place in the slot.
Repeat for all modules (see step 1 above).
Memory Support
The X5DE8-GG/X5DEI-GG/X5DEE-M only supports registered ECC DDR-266 and
200 (PC2100 and PC1600) SDRAM memory. Do not mix both types.
Figure 2-2.
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Pay attention
to the
alignment
notch at the
bottom.
CAUTION
to prevent any possible damage.
Installing and Removing DIMMs
2-5
Chapter 2: Installation