Scsi Channel Termination Enable/Disable; Scsi Enable/Disable; Lan1/2 Enable/Disable - Supermicro X5DEE-M User Manual

SUPER X5DE8-GG/X5DEI-GG/X5DEE-M User's Manual
SCSI Channel Termination
Enable/Disable (X5DE8-GG)
Jumpers JPA1 and JPA2 allow you to
enable or disable termination for each
SCSI channel. Jumper JPA1 controls
channel A and JPA2 controls channel
B. The default setting is open to en-
able (teminate) both SCSI channels.
If you wish to connect external SCSI
devices, you should disable termina-
tion for the channel(s) you will be con-
necting them to. Note that the exter-
nal SCSI port is for use with
rackmount chassis only.
table on the right for jumper settings.

SCSI Enable/Disable

(X5DE8-GG)
The SCSI Termination jumper at
JPA3 allows you to enable or dis-
able the onboard SCSI controller.
The normal (default) position is on
pins 1-2 to enable (terminate) the
onboard SCSI.
the right for jumper settings.

LAN1/2 Enable/Disable

Change the setting of jumper JPL1
(for LAN1) or JPL2 (for LAN2) to
enable or disable the Ethernet
ports on the motherboard. See the
table on the right for jumper set-
tings. The default setting is en-
abled.
Note: the X5DEE-M has a single
LAN port and thus a single jumper.
See the
See the table on
2-16
SCSI Channel T ermination
Enable/Disable
Jumper Settings
(JPA1, JPA2)
Jumper
Position Definition
Open Enabled
Closed Disabled
SCSI Enable/Disable
Jumper Settings
(JPA3)
Jumper
Position Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
LAN1/2
Enable/Disable
Jumper Settings
(JPL1, JPL2)
Jumper
Position Definition
Pins 1-2 Enabled
Pins 2-3 Disabled