Table of Contents
Advertisement
S
UPER X5DE8-GG/X5DEI-GG/X5DEE-M User's Manual
If you are a system integrator, VAR or OEM, a POST diagnos-
tics card is recommended. For I/O port 80h codes, refer to
Memory Errors
1. Make sure the DIMM modules are properly and fully installed.
2. Determine if different speeds of DIMMs have been installed and verify
that the BIOS setup is configured for the fastest speed of RAM used.
It is recommended to use the same RAM speed for all DIMMs in the
system.
3. Make sure you are using registered ECC, PC1600 or PC2100 DDR-RAM.
EDO SDRAM and PC100/133 SDRAM are not supported.
4. Check for bad DIMM modules or slots by swapping a single module be-
tween two slots and noting the results.
5. Make sure all memory modules are fully seated in their slots. See Chap-
ter 2 Section 3 for details.
6. Check the position of the 115V/230V switch on the power supply.
Losing the System's Setup Configuration
1. Ensure that you are using a high quality power supply.
power supply may cause the system to lose the CMOS setup informa-
tion. Refer to Section 1-6 for details on recommended power supplies.
2. The battery on your motherboard may be old. Check to verify that it still
supplies ~3VDC. If it does not, replace it with a new one.
3. If the above steps do not fix the Setup Configuration problem, contact
your vendor for repairs.
3-2
Technical Support Procedures
Before contacting Technical Support, please take the following steps. Also,
note that as a motherboard manufacturer, SuperMicro does not sell directly
to end-users, so it is best to first check with your distributor or reseller for
troubleshooting services.
with the specific system configuration that was sold to you.
NOTE
App. B.
They should know of any possible problem(s)
3-2
A poor quality
Advertisement
Table of Contents
