Drive Bay Installation/Removal; Accessing The Drive Bays - Supermicro SUPERSERVER 6023L-8R User Manual

S S
UPER ERVER 6023L-8R Manual
6-4

Drive Bay Installation/Removal

Accessing the Drive Bays

SCSI Drives: You do not need to access the inside of the chassis to
replace or swap SCSI drives. Proceed to the next step for instructions.
Note: You must use standard 1" high, 80-pin SCA SCSI drives in
the SuperServer 6023L-8R.
CD-ROM/Floppy Disk Drive: For installing/removing the CD-ROM or floppy
disk drive, you will need to gain access to the inside of the 6023L-8R by
removing the top cover of the chassis. Proceed to the "CD-ROM and
Floppy Drive Installation" section later in this chapter for instructions.
5 1/4" Drive Bay: For installing/removing a component in the 5 1/4" drive
bay, proceed to the "5 1/4" Drive Bay Installation" section later in this
chapter for instructions.
Figure 6-2. System Cooling Fans
6-4