Table of Contents
Advertisement
!
HDD: Indicates IDE channel activity. On the SuperServer 6023L-8R,
this LED indicates CD-ROM drive activity when flashing.
!
Power:
supply units. This LED should normally be illuminated when the system is
operating.
3-4
SCSI Drive Carrier LEDs
A SCSI drive carrier has two LEDs.
!
Green: When illuminated, the green LED on the front of the SCSI drive
carrier indicates drive activity.
enables this LED to blink on and off when that particular drive is being
accessed.
!
Red:
A SAF-TE compliant backplane is needed to activate the red
LED, which indicates a drive failure. (A SAF-TE compliant SCSI backplane
is standard on the 6023L-8R.) If one of the SCSI drives fail, you should be
notified by your system management software.
for instructions on replacing failed SCSI drives.
3-5
Motherboard LED
There is only one LED on the motherboard, which is designated CR5 and is
located in the corner of the X5DLR-8G2 near the JA1 SCSI connector. The
CR5 LED can be one of three different colors. When green, it indicates that
power is present on the motherboard.
present on the motherboard. Red indicates an incorrect or missing CPU.
Indicates power is being supplied to the system's power
A connection to the SCSI SCA backplane
Chapter 3: System Interface
Please refer to Chapter 6
Yellow indicates standby power is
3-3
Advertisement
Table of Contents
