Table of Contents
Advertisement
6. Check all cable connections and airflow:
Make sure all power and data cables are properly connected and not
blocking the chassis airflow. See Chapter 5 for details on cable connec-
tions.
2-6
Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SCSI
drives and SCA backplane have been properly installed and all connec-
tions have been made.
1. Accessing the drive bays:
All drives can be accessed from the front of the server.
the CD-ROM and floppy drives, you will need to remove the top chassis
cover. The SCSI disk drives can be installed and removed from the front
of the chassis without removing the top chassis cover. The 5.25" drive
bay cover can be removed by pressing the tab on the corner of the drive
bay and then pushing the bay outward from the inside.
2. CD-ROM and floppy disk drives:
A slim CD-ROM and a floppy drive should be preinstalled in your server.
Refer to Chapter 6 if you need to reinstall a CD-ROM and/or floppy disk
drive to the system.
3. 5.25" drive bay:
The 5.25" drive bay comes without a preinstalled drive. Refer to Chapter
6 if you need to install a component (such as an IDE hard drive) into the
5.25" drive bay.
4. Check the SCSI disk drives:
Depending upon your system's configuration, your system may have one
or more drives already installed. If you need to remove or install SCSI
drives, please refer to Chapter 6.
Chapter 2: Server Installation
2-9
For servicing
Advertisement
Table of Contents
