Table of Contents
Advertisement
S
S
UPER
ERVER 5015M-MR(+)/5015M-MF(+) User's Manual
CD-ROM Drive Installation (5015M-MR(+))
The top cover of the chassis must be opened to gain full access to the CD-ROM
drive bay. The CD-ROM must have a "slim" profi le to fi t into the 5015M-MR(+). If
you cannot remove the top cover with the system remaining in the rack, follow the
procedure below.
First, shutdown the system and disconnect all cables from the back of the server
chassis. Make sure the system is supported from underneath then remove the
front bracket screws that secure the unit to the rack. Carefully lift the server out
of the rack.
Open the cover by following the procedure described on page 6-7. You must power
down the system before installing or removing CD-ROM or Serial ATA drives. Re-
move the two screws that secure the CD-ROM drive to the chassis and then lift the
drive out of the chassis. See Figure 6-4.
Note: A red mark on a wire typically designates the location of pin 1.
The CD-ROM may only be used as a Master IDE device.
Figure 6-4. Removing the SATA/CD-ROM/ Drive [5015M-MR(+) only]
6-6
Advertisement
Table of Contents
