Cd-Rom And Floppy Drive Installation - Supero SUPERSERVER 6017R-TDF User Manual

S S
UPER ERVER 6017R-TDF Manual

CD-ROM and Floppy Drive Installation

The top cover of the chassis must be opened to gain full access to the CD-ROM
and fl oppy drive bays. The 6017R-TDF accomodates only slim CD-ROM drives.
Side mounting brackets are needed to mount a slim CD-ROM drive in the 6017R-
TDF server.
You must power down the system before installing or removing a fl oppy or CD-
ROM drive.
1. With the chassis cover removed, unplug the power and data cables from the
drive you want to remove.
2. Locate the locking tab at the rear of the drive. It will be on the left side of the
drive when viewed from the front of the chassis.
3. Pull the tab away from the drive and push the drive unit out the front of the
chassis.
4. Add a new drive by following this procedure in reverse order. You may hear a
faint *click* of the locking tab when the drive is fully inserted.
5. Remember to reconnect the data and power cables to the drive before replac-
ing the chassis cover and restoring power to the system.
Please be aware of the following:
•
The fl oppy disk drive cable has seven twisted wires.
•
A color mark on a cable typically designates the location of pin 1.
•
A single fl oppy disk drive ribbon cable has 34 wires and two connectors to
provide for two fl oppy disk drives. The connector with twisted wires always
connects to drive A, and the connector that does not have twisted wires always
connects to drive B.
6-8