Table of Contents
Advertisement
Chapter 6: Advanced Chassis Setup
CD-ROM and Floppy Drive Installation
The top cover of the chassis must be opened to gain access to the CD-ROM and
floppy drive bays. The 6033P-8R accomodates only slim CD-ROM drives. Side
mounting brakets are typically needed to mount a slim CD-ROM drive in the
6033P-8R server.
To remove the CD-ROM or floppy drive carrier, first power down the system and
then remove the top cover of the chassis. Push the latch located at the rear of
the CD-ROM or floppy drive bay and then push the drive bay out through the front
of the chassis. See Figures 6-7a and 6-7b for illustrations of removing these
drives. The illustrations also show how to mount each drive on the rails, which
are needed to slide them into the open chassis bays. Reverse this procedure to
re-install the drives, making sure the latch clicks when re-inserting the drive bay
into the chassis. Replace the top cover when finished.
Note: The red wire on a ribbon cable typically designates the location of pin 1.
Figure 6-7a. CD-ROM Drive Installation
6-9
Advertisement
Table of Contents
