5-12 Parallel Port And Peripheral Drive Connections; Parallel Port; Ipmi Socket - Supero SUPERSERVER 5015M-MF User Manual

5-12 Parallel Port and Peripheral Drive Connections

Use the following information to connect the IDE hard disk drive cables.
• A red mark on a wire typically designates the location of pin 1.
• The 80-wire ATA100/66 IDE hard disk drive cable that came with your system
has two connectors to support two drives. This special cable should be used
to take advantage of the speed this new technology offers. The blue connector
connects to the onboard IDE connector interface and the other connector(s) to
your hard drive(s). Consult the documentation that came with your disk drive
for details on actual jumper locations and settings for the hard disk drive.
Parallel Port Connector
The parallel port is a header on
the motherboard near PCI slot.
See the table at right for pin
defi nitions.

IPMI Socket

The IPMI 2.0 socket on the
serverboard is included for
the use of an IPMI (Intelligent
Management Platform Inter-
face) card.
Chapter 5: Advanced Motherboard Setup
Parallel (Printer) Port Connector
Pin Defi nitions (J30)
Pin# Defi nition
1 Strobe-
3 Data Bit 0
5 Data Bit 1
7 Data Bit 2
9 Data Bit 3
11 Data Bit 4
13 Data Bit 5
15 Data Bit 6
17 Data Bit 7
19 ACK
21 BUSY
23 PE
25 SLCT
5-21
Pin # Defi nition
2 Auto Feed-
4 Error-
6 Init-
8 SLCT IN-
10 GND
12 GND
14 GND
16 GND
18 GND
20 GND
22 Write Data
24 Write Gate
26 NC