S
S
UPER
ERVER 5015B-MF User's Manual
Figure 2-4. Installing the Server into a Telco Rack
2-5
Checking the Motherboard Setup
After you install the 5015B-MF in the rack, you will need to open the unit to make
sure the motherboard is properly installed and all the connections have been
made.
Accessing the Inside of the System
1.
If you installed with rails, grasp the two handles on either side and pull the
unit straight out until it locks (you will hear a "click").
2.
Remove the screw at the back of the chassis that secures the top cover.
3.
Depress the two buttons on the top of the chassis to release the top cover
from the locked position. Push the cover away from you until it stops.
4.
Lift the top cover from the chassis to gain full access to the inside of the
server. See Figure 2-5.
2-8