Table of Contents
Advertisement
S
S
UPER
ERVER 5015B-MF User's Manual
Installing/Removing a Serial ATA Drive
The hard drive is mounted in a tray at the right rear area of the server. This tray is
quipped with rubber grommets to reduce vibration (Figure 6-3, #1).
1.
Remove the screws that secure the hard drive to the chassis and then lift it of
the standoffs, as shown in Figure 6-4.
2.
To remove a hard drive, unscrew the screws that secure it to the tray (Figure
6-3, #3) and then remove the drive.
3.
To add a drive, position it in the tray with the printed circuit board side facing
down and with the holes in the drive and the holes in the tray aligned. You
can install it in either the top or the bottom half of the tray.
4.
Secure the drive to the tray with four screws (two on each side), as shown in
Figure 6-3.
5.
After you have fi nished installing the hard drive, replace the top cover on the
chassis, push the server back into the rack and restore the power.
6-4
Advertisement
Table of Contents
