Table of Contents
Advertisement
S
S
UPER
ERVER 5015B-MF User's Manual
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the motherboard to provide you with system control buttons and
status indicators. These wires have been bundled together in a ribbon cable to
simplify the connection. Connect the cable from JF1 on the motherboard to the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connections. Pull all excess cabling out of the airfl ow path. The LEDs inform
you of system status. See Chapter 3 for details on the LEDs and the control panel
buttons. Details on JF1 can be found in Chapter 5.
6-3
System Fan
A 10-cm blower fan provides the cooling for the SuperServer 5015B-MF. The chas-
sis includes air seals under the blower fan and at the chassis cross section, which
separates the drive bay area from the motherboard area of the chassis to promote
better airfl ow. It is highly important that the air seal is properly installed and making
a good seal in order for the cooling air to circulate properly through the chassis.
Figure 6-1. Chassis Front View
Figure 6-2. Chassis Rear View
6-2
Advertisement
Table of Contents
