Table of Contents
Advertisement
S
S
UPER
ERVER 5015B-MF User's Manual
2-4
Installing the System into a Rack
This section provides information on installing the SuperServer 5015B-MF into a
rack unit. If the system has already been mounted into a rack, you can skip ahead
to Sections 2-5 and 2-6.
Basic Installation Procedure
The 5015B-MF server comes with two rack mounting brackets, which are located
on each side at the front of the chassis. To mount the system into a rack, simply
screw these brackets directly to the front of the rack (two screws for each bracket).
You may also detach the brackets from the chassis and move them back approx.
4 inches, where you will see a group of three holes to secure them to. You may
then secure them to the rack as just described. Note that installing in this manner
may prevent you from closing the rack door.
Installing with Optional Rackmount Kit (CSE-PT8)
This section is only for customers that have the optional rack mount kit.. Each of
these assemblies consist of two sections: an inner rail that secures to the chassis
and an outer rail that secures directly to the rack itself (see Figure 2-1). This is a
guideline for installing the unit into a rack with the optional rack kit. You should also
refer to the installation instructions that came with the rack unit you are using. Be
Figure 2-1. Identifying the Rail Sections
Inner (chassis) rail
Outer (rack) rail
2-4
Advertisement
Table of Contents
