Table of Contents
Advertisement
6-4
Drive Bay Installation/Removal
Accessing the Drive Bay
Hard Drive: The hard drive in the 5015B-MF is not hot-swappable. The system
must be shutdown and power removed when the hard drive is installed removed.
You must also fi rst remove the cover to access the inside of the system. Proceed
to the next section for instructions.
CD-ROM/Floppy Disk Drives: There is no fl oppy drive or CD-ROM drive included
in the 5015B-MF.
The fan can adjust its speed according to the heat level sensed in the system,
which results in more effi cient and quieter fan operation. Fan speed is controlled
by a setting in BIOS (see page 7-11).
System Fan Failure
If the fan fails, you will need to have it replaced with the same type. Contact your
vendor or Supermicro for information on replacement fans.
Serial ATA Drive Installation
Accessing the Inside of the System
1.
First, release the retention screws that secure the unit to the rack. If you
installed with rails, grasp the two handles on either side and pull the unit
straight out until it locks (you will hear a "click").
2.
Remove the screw at the back of the chassis that secures the top cover.
3.
Depress the two buttons on the top of the chassis to release the top cover
from the locked position. Push the cover away from you until it stops.
4.
Lift the top cover from the chassis to gain full access to the inside of the
server. See Figure 2-5.
Chapter 6: Advanced Chassis Setup
6-3
Advertisement
Table of Contents
